(323) 284-1068Call Now

Sub-Zero Ice Maker Repair Inside Your Refrigerator

No ice, slow ice, hollow cubes or a leaking fill tube in your Sub-Zero refrigerator, traced from the water supply to the module.

4.9 (739 Reviews)
Call (323) 284-1068
Quick Summary

Sub-Zero ice maker repair in Los Angeles puts the ice maker in your refrigerator's freezer back to work, and most faults sit in the water filter, water inlet valve, a frozen fill tube, the module or a warm freezer.

  • Sub-Zero ice maker repair Los Angeles
  • Sub-Zero ice maker not making ice
  • Sub-Zero ice maker service
  • Ice maker leaking water
  • Water inlet valve replacement

How We Trace a Sub-Zero Ice Maker Fault

  1. Check the household supply valve and the line behind the unit for kinks.
  2. Replace a clogged water filter as routine maintenance.
  3. Test the water inlet valve solenoid for power and flow.
  4. Thaw and inspect the fill tube for an ice blockage.
  5. Confirm the freezer holds temperature, since a warm freezer slows ice.
  6. Cycle the Sub-Zero module, ejector and shut-off arm or bin sensor.

Ice Maker Symptoms and Likely Causes

  • No ice: closed supply valve, failed inlet valve or module
  • Small or hollow cubes: clogged filter or low water flow
  • Water on the floor: cracked fill tube or an overfilling mold
  • Clumped or stale ice: warm freezer or an old filter

A warm freezer is handled with Sub-Zero freezer repair and cooling faults with Sub-Zero refrigerator repair. Ice maker visits run from Malibu inland under our Sub-Zero refrigerator repair in Los Angeles service.

Each Sub-Zero visit brings a diagnosis, a quote in writing and OEM parts for built-in, panel-ready and custom models, with a 90-day warranty; ejector noise, frost, gasket wear and any display code are checked too.

Frequently Asked Questions

Confirm the ice maker switch is on and the shut-off arm sits down; after that, the usual suspects are a clogged water filter, a frozen fill tube or a dead water inlet valve.
Water on the floor points to a cracked fill tube, a loose supply line behind the refrigerator, or an inlet valve stuck open that overfills the ice mold.
Weak water flow from a clogged filter, a half-open supply valve or a tired inlet valve leaves the mold short-filled, so cubes come out thin or hollow.

Refrigerator Down? Call Before 2 PM

Same-day visits across Los Angeles, OEM parts and a 90-day warranty.

Call (323) 284-1068